LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Wiper System And Washer System) >> Diagnostic Information and Procedures >> Low Washer Fluid Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the washer fluid level sensor.
  2. Washer fluid level switch open, test for infinite resistance between the signal terminal 2 and the ground terminal 1.
    • If not the specified value, replace the washer fluid level sensor.
  3. Washer fluid level switch closed, test for less than 2 ohms between the signal terminal 2 and the ground terminal 1.
    • If not within the specified range, replace the washer fluid level sensor.
scientia non olet · About LEMON Manuals