LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0340 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2199: Intake Air Temperature (IAT) Sensors 1-2 Not Plausible >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 1 and 2 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  1. Ignition ON.
  2. Verify the following scan tool parameters are within 10°C (18°F) of each other.
    • Start-Up IAT Sensor 1
    • Start-Up IAT Sensor 2
    • Start-Up ECT
    • If not within 10°C (18°F) 

      Refer to Circuit/System Testing.

    • If within 10°C (18°F) 
  3. Engine idling, verify the following scan tool parameters are between -38 to +149°C (-36 to +300°F).
    • IAT Sensor 1
    • IAT Sensor 2
    • ECT Sensor
    • If not between -38 to +149°C (-36 to +300°F) 

      Refer to Circuit System Testing.

    • If between -38 to +149°C (-36 to +300°F) 
  4. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  5. Verify the DTC does not set.
    • If any DTC sets 

      Refer to Circuit/System Testing.

    • If no DTC sets 
  6. All OK
scientia non olet · About LEMON Manuals