LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0340 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P163A: Control Module Fuel Pressure Regulator 1 Control System Circuitry Performance >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the parameters listed below do not display Malfunction when commanding the Fuel Pressure Regulator On and Off with a scan tool.
    • Fuel Pressure Regulator Control Circuit High Voltage Test Status
    • Fuel Pressure Regulator Control Circuit Open Test Status
    • Fuel Pressure Regulator Control Circuit Low Voltage Test Status
    • Fuel Pressure Regulator High Control Circuit High Voltage Test Status
    • Fuel Pressure Regulator High Control Circuit Open Test Status
    • Fuel Pressure Regulator High Control Circuit Low Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals