LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0340 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0496: Evaporative Emission (EVAP) System Flow During Non-Purge >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF.
  2. Command the EVAP Purge/Seal function to System Seal or Not Venting with a scan tool to seal the EVAP system.
  3. Start the engine.
  4. Observe the Fuel Tank Pressure Sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 V after 90 s.
    • If not within specifications 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve

    • Within Specifications 
  5. All OK
scientia non olet · About LEMON Manuals