LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Engine Controls And Fuel - 3.6L (LLT) - DTC P0340 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0446: Evaporative Emission (EVAP) Vent System Performance >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify DTC P0449 is not set.
    • If the DTC is not set 
  3. Ignition OFF, remove the fuel tank filler cap or install GE 41415-60 for capless vehicles. Ignition ON.
  4. Verify the scan tool Fuel Tank Pressure Sensor voltage parameter is within 1.3-1.7 V.
    • If not between the 1.3-1.7 V 

      Refer to P0452, P0453 within DTC P0451-P0454 .

    • If between the 1.3-1.7 V 
  5. Install the fuel tank filler cap or remove the GE 41415-60. Engine idling at operating temperature for 5 min,
  6. Verify the scan tool Fuel Tank Pressure Sensor parameter does not increase to greater than 2.5 V when commanding the EVAP Purge Solenoid Valve to 50%.
    • If greater than 2.5 V 

      Refer to Circuit System Testing.

    • If 2.5 V or less 
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/failure Records data.
    • If the DTC sets 

      Refer to Circuit System Testing.

    • If the DTC does not set 
  8. All OK.
scientia non olet · About LEMON Manuals