Pump Assembly Installation
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Pump Assembly Installation
| Callout | Component Name |
|---|---|
| 1 | Driven Sprocket Thrust Washer |
| 2 | Drive Sprocket Thrust Washer |
| 3 | Install Drive Link Assembly
NOTE:
Install as an assembly. |
| 4 | A/Trans Fluid Pump Assembly
NOTE:
Rotating the drive sprocket and link assembly while installing the oil pump will aid in aligning the driven sprocket and oil pump drive shaft splines. |
| 5 | A/Trans Fluid Pump Bolt M6 x 25 (Qty: 3)
CAUTION:
Refer to Fastener Caution . Procedure: Tighten in sequence shown. Tighten 12 N.m (106 lb in). |