LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Automatic Transmission - 6T75 (M7V M7X) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Front Differential Transfer Drive Gear Support Assembly Disassemble >> Seal Removal

Seal Removal

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Differential Transfer Drive Gear Support Seal
GM1737841Courtesy of GENERAL MOTORS COMPANY
Seal Removal

Callout Component Name
CAUTION:

Do not remove the transfer drive gear bearing retaining nut. The drive gear and bearing are not serviceable. Removing the retaining nut will damage the support.

Preliminary Procedure

    NOTE:

    The bushing inside the front differential transfer drive gear support may appear broken. This is the normal appearance of the bushing.

  • Inspect the support assembly for damage or wear to the splines, bushings, machined surfaces and threaded holes.
  • Inspect the transfer drive gear for damage or wear.
  • Inspect the transfer drive gear bearing assembly for proper operation.
  • The bearing should roll smoothly and quietly.
1 Front Differential Transfer Drive Gear Support Seal

Special Tools

  • DT 23129  Universal Seal Remover
  • GE 6125-1B  Slide Hammer with Adapter or equivalent

For equivalent regional tools, refer to Special Tools .
2 Front Differential Transfer Drive Gear Support Torque Converter Fluid Seal Assembly