Drive Support Seal Installation
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Drive Support Seal Installation
| Callout | Component Name |
|---|---|
| 1 | Front Differential Transfer Drive Gear Support Seal
NOTE:
A NEW seal must be installed. Special Tools DT-46624 Support Seal Installer For equivalent regional tools, refer to Special Tools . |
| 2 | Small Chamfer Faces Up
CAUTION:
To avoid damaging the seal, first place DT 46624-1 with the small chamfer end facing up and leave in place for at least 60 seconds. |
| 3 | Large Chamfer Faces Up
NOTE:
Turn DT 46624-1 which is part of DT-46624 seal installer, over with the large chamfer end facing up for 60 seconds to ensure that the seal has been properly sized. |