Front Differential Drive Pinion Gear Bearing Replacement: Removal

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Differential Drive Pinion Gear Bearing

Courtesy of GENERAL MOTORS COMPANY

Removal

Callout	Component Name
1	Front Differential Drive Pinion Gear Bearing NOTE: When removing the front differential drive pinion gear bearing use DT 41816-2 step plate. Use DT 8433-1 puller bar or equivalent with bolts 2-3/8 x 3 x 24. Special Tools DT 8433-1 Puller Bar or equivalent DT 22912-B Split Plate Bearing Remover or equivalent DT 41816-2 Step Plate For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Front Differential Drive Pinion Gear Bearing

NOTE:

When removing the front differential drive pinion gear bearing use DT 41816-2 step plate.
Use DT 8433-1 puller bar or equivalent with bolts 2-3/8 x 3 x 24.

Special Tools

DT 8433-1 Puller Bar or equivalent
DT 22912-B Split Plate Bearing Remover or equivalent
DT 41816-2 Step Plate

For equivalent regional tools, refer to Special Tools .