LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Automatic Transmission - 6T75 (M7V M7X) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Front Differential Drive Pinion Gear Bearing Cup and Lubricant Dam Replacement >> Removal

Front Differential Drive Pinion Gear Bearing Cup and Lubricant Dam Replacement: Removal

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Differential Drive Pinion Gear Bearing Cup & Lube Dam
GM1737815Courtesy of GENERAL MOTORS COMPANY
Removal

Callout Component Name
1 Front Differential Drive Pinion Gear Bearing Cup
CAUTION:

Failure to apply the lubricant will cause damage to the bolt and nut threads.

NOTE:
  • Tighten DT-45094  cup remover until it fits snugly on the bearing cup.
  • Adjust DT 45124  removal bridge so it sits on the case surface just beyond the bearing cup opening.
  • Apply the extreme pressure lubricant DT 23444-A  extreme press lubricant to the puller bolt threads to prevent damage to the bolt threads during bearing cup removal.
  • Hold the puller bridge nut and turn the bolt to remove the bearing cup.

Special Tools

  • DT 23444-A  Extreme Press Lubricant - 1/4 Ounce Tube
  • DT-45094  Bearing Cup Remover
  • DT 45124  Removal Bridge

For equivalent regional tools, refer to Special Tools .
2 Front Differential Drive Pinion Gear Lube Dam

Special Tools

  • DT-48055  Lube Dam Removal
  • GE 6125-1B  Slide Hammer with Adapter

For equivalent regional tools, refer to Special Tools .