Rocker Panel Front Molding Replacement (Traverse)

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rocker Panel Front Molding (Traverse)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open front and rear side doors. Remove the front and rear side door lower weatherstrip. Refer to Front or Rear Side Door Lower Weatherstrip Replacement .
1	Front Wheelhouse Liner Bolt (Qty: 4) CAUTION: Refer to Fastener Caution .
2	Rocker Panel Front Molding Procedure Using a trim-type release tool start from the front end of the rocker panel front molding and release the 21 retainers.

Callout

Component Name

Preliminary Procedures

Open front and rear side doors.
Remove the front and rear side door lower weatherstrip. Refer to Front or Rear Side Door Lower Weatherstrip Replacement .

Front Wheelhouse Liner Bolt (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Rocker Panel Front Molding
Procedure
Using a trim-type release tool start from the front end of the rocker panel front molding and release the 21 retainers.