Circuit/System Description

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

The stop lamp switch signal circuit is a direct hardwire input to the transmission control module (TCM) from the body control module (BCM). The TCM module monitors the stop lamp signal circuit in order to detect when the brake pedal has been applied. When the brake pedal is pressed, the BCM sends a High Speed GM Lan message to the engine control module (ECM) indicating that the brake pedal has been applied. The BCM also sends a high voltage signal on the stop lamp signal circuit to the TCM module. The TCM module sends a universal asynchronous receiver transmitter low speed GM Lan message to the ECM indicating that a brake pedal application has occurred. The ECM will compare the GM LAN Low speed and GM LAN High Speed data message in order to confirm that both serial data messages match.