LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 488 (Lighting System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC C0277 or C0890: Brake Pedal Position Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Brake Pedal Position Sensor Learned Release Position parameter, located in the BCM Chassis Control Data display, is within 0.1 V of the Brake Pedal Position Sensor parameter when the brake pedal is fully released.
    • If the difference is less than 0.1 V 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals