Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Clutch Drum, Retaining Clip & Weather Seal

Courtesy of GENERAL MOTORS COMPANY

Install the NEW O-ring (4) and the retaining clip (3) on the clutch assembly.
Install the clutch assembly (1) in the torque tube.
Position the wiring harness and weather seal (2) in the torque tube.

Fig 2: Electrical Harness Retainer And Torque Tube

Courtesy of GENERAL MOTORS COMPANY

Install the electrical harness retaining clip (1) in the torque tube (2).

Fig 3: View Of Clutch Control Module & Electrical Connector

Courtesy of GENERAL MOTORS COMPANY

Install the electrical connector (1) to the clutch control module (2).
Install the torque tube assembly. Refer to Driveline Torque Tube Replacement
Program the rear differential clutch control module. Refer to Control Module References .