LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Object Detection System And Pedestrian Protection System) >> Diagnostic Information and Procedures >> DTC B0958, B0959, B0960, or B0961: Parking Aid Rear Sensor >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

B0958 01, B0959 01, B0960 01, or B0961 01 

Voltage seen on the object alarm sensor signal circuit is greater than 11.5 V or the object alarm sensor is not grounded.

B0958 06, B0959 06, B0960 06, or B0961 06 

Voltage seen on the object alarm sensor signal circuit is less than 0.5 V.

B0958 08, B0959 08, B0960 08, or B0961 08 

An invalid signal is received by the object alarm module.

B0958 21, B0959 21, B0960 21, or B0961 21 

The object alarm sensor determines no change in the position of an object while the vehicle is in motion.

B0958 3A, B0959 3A, B0960 3A, B0961 3A 

The object alarm module determines there is an incorrect sensor installed.

scientia non olet · About LEMON Manuals