LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 480 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Liftgate Ajar Indicator Malfunction (TB4) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the A23C Liftgate Latch Assembly.
  2. Test for less than 1 Ω between the ground circuit terminal 5 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Rear Closure Ajar Sw. parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 6 for a short to ground. If the circuit tests normal, replace the K9 Body Control Module.
  4. Install a 3A fused jumper wire between the signal circuit terminal 6 and ground. Verify the scan tool Rear Closure Ajar Sw. parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal replace the K9 Body Control Module.
  5. If all circuits test normal, test or replace the A23C Liftgate Latch Assembly.
scientia non olet · About LEMON Manuals