LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 480 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Door Ajar Indicator Malfunction (Without AXE) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Driver Door Open Sw parameter changes between Open and Closed when opening and closing the driver door.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Driver Door Ajar Switch Malfunction.

    • If the parameter changes 
  3. Verify the scan tool Passenger Door Open Sw parameter changes between Open and Closed when opening and closing the passenger door.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Passenger Door Ajar Switch Malfunction.

    • If the parameter changes 
  4. Verify the scan tool Left Rear Door Ajar Sw parameter changes between Door Closed and Door Ajar when opening and closing the left rear door.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Left Rear Door Ajar Switch Malfunction.

    • If the parameter changes 
  5. Verify the scan tool Right Rear Door Ajar Sw parameter changes between Door Closed and Door Ajar when opening and closing the right rear door.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Right Rear Door Ajar Switch Malfunction.

    • If the parameter changes 
  6. All OK.
scientia non olet · About LEMON Manuals