Circuit/System Verification
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- With the liftgate closed, observe the scan tool Liftgate Latch Pawl, Ratchet, and Sector Switch parameters. Each parameter status should be as listed below:
- LGM Latch Pawl Sw parameter - Inactive
- LGM Latch Ratchet Sw. parameter - Inactive
- Liftgate Latch Sector Switch parameter - Inactive
- With the liftgate open, observe the scan tool Liftgate Latch Pawl, Ratchet, and Sector Switch parameters. Each parameter status should be as listed below:
- LGM Latch Pawl Sw parameter - Active
- LGM Latch Ratchet Sw. parameter - Active
- LGM Latch Sector Sw. parameter - Inactive
- Sector Switch Test - Close the liftgate allowing the cinch motor to pull the liftgate closed. Observing the scan tool LGM Latch Sector Sw. parameter while the liftgate is being automatically cinched closed; the parameter should change from Inactive to Active then back to Inactive within 10 seconds.