LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (Seat Heating System And Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B2345: Seat Heater (Dealer Installed) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

B2345 00

  1. Ignition OFF, disconnect the X1 harness connector at the K29 Seat Heating Control Module.
  2. Test for infinite resistance between the control circuit terminal 3 and ground.
    • If not the specified value, test the control circuits listed below for a short to ground:
    • Driver seat cushion and seat back element terminal 3
    • Driver seat cushion element terminal 5
    • Driver seat back element terminal 1
  3. Test for infinite resistance between the control circuit terminal 6 and ground.
    • If not the specified value, test the control circuits listed below for a short to ground:
    • Passenger seat cushion and seat back element terminal 6
    • Passenger seat cushion element terminal 2
    • Passenger seat back element terminal 4
  4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.
    • If the test lamp illuminates, test the control circuits listed below for a short to voltage:
    • Driver seat cushion and seat back element terminal 3
    • Driver seat cushion element terminal 5
    • Driver seat back element terminal 1
  5. Verify that a test lamp does not illuminate between the supply voltage circuit terminal 6 and ground.
    • If the test lamp illuminates, test the control circuits listed below for a short to voltage:
    • Passenger seat cushion and seat back element terminal 6
    • Passenger seat cushion element terminal 2
    • Passenger seat back element terminal 4
  6. If all circuits test normal, replace the K29 Seat Heating Control Module.

B2345 13

  1. Ignition OFF, disconnect the X2 and X4 harness connectors at the K29 Seat Heating Control Module.
  2. Test for greater than 850 Ω between the signal and the low reference circuit terminals listed below:
    • Driver seat cushion terminal 9 X4 and terminal 6 X2
    • Passenger seat cushion terminal 20 X4 and terminal 8 X2
    • If less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the appropriate E14B or E14D Seat Heating Element - Cushion.
  3. Test for greater than 850 Ω between the signal and the low reference circuits listed below:
    • Driver seat back terminal 19 X4 and terminal 5 X2
    • Passenger seat back terminal 10 X4 and terminal 7 X2
    • If less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the appropriate E14A or E14C Seat Heating Element - Back.
  4. If all circuits test normal, replace the K29 Seat Heating Control Module.

B2345 42 or B2345 4B 

If either DTC is set, replace the K29 Seat Heating Control Module.

scientia non olet · About LEMON Manuals