LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Engine Cooling System) >> Repair Instructions >> Cooling System Draining and Filling (Static Fill) >> Filling Procedure

Filling Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:

    The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.

  1. Install the radiator outlet hose to the engine. Refer to Radiator Outlet Hose Replacement .
    2. CAUTION:

    Refer to Fastener Caution .

  2. If the engine block drain plug was removed, perform the following:
    1. Apply pipe sealer to the drain plugs.
    2. Install the engine block drain plugs.

      Tighten 

      Tighten the engine block drain plug to 22 N.m (16 lb ft).

  3. Lower the vehicle.
    4. NOTE:

    Use a 50/50 mixture of DEX-COOL antifreeze and clean, drinkable water.

  4. Slowly fill the cooling system with a 50/50 coolant mixture. Refer to Approximate Fluid Capacities .
  5. Install the coolant pressure cap.
  6. Start the engine.
  7. Run the engine at 2, 000-2, 500 RPM until the engine reaches normal operating temperature.
  8. Allow the engine to idle for 3 minutes.
  9. Shut the engine OFF.
  10. Allow the engine to cool.
  11. Top off the coolant as necessary.
  12. Inspect the concentration of the engine coolant, using the J 26568  coolant and battery tester.
  13. Rinse away any excess coolant from the engine and the engine compartment.
scientia non olet · About LEMON Manuals