LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Transfer Case - GETRAG 790) >> Repair Instructions - On Vehicle >> Rear Output Shaft Housing O-Ring Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the transfer case fluid. Refer to Transfer Case Fluid Replacement .
  3. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement .
  4. Remove the rear output shaft housing. Refer to Rear Output Shaft Housing Removal in Transfer Case Disassemble .
  5. Remove the transfer case rear output shaft housing seal O-ring. Refer to rear output shaft housing removal in Transfer Case Disassemble 
scientia non olet · About LEMON Manuals