LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Transfer Case - GETRAG 790) >> Repair Instructions - On Vehicle >> Intermediate Drive Shaft Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate shaft bearing and retainers to the intermediate drive shaft. Refer to Intermediate Drive Shaft Assembly in Transfer Case Assemble .
    2. NOTE:

    Special tool DT-48094 must be used to install the intermediate shaft. 

  2. Install the intermediate shaft and snap ring into the transfer case. Refer to Intermediate Drive Shaft Assembly in Transfer Case Assemble .
    3. Fig 1: Identifying Transfer Case & Bolts
    GM2039429Courtesy of GENERAL MOTORS COMPANY
  3. Install the transfer case assembly (2). Refer to Transfer Case Assembly Replacement .
  4. Fill the transfer case with fluid. Refer to Transfer Case Fluid Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals