Rear Output Shaft Housing Disassembly

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Rear Output Shaft Housing

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transfer Case Rear Output Shaft Gear Nut Procedure Use a 30 mm socket or J-29873 Nozzle Socket 30 mm. Special Tools J-08614-A Pinion Flange Holder and Remover J 29873 Nozzle Socket 30 mm For equivalent regional tools, refer to Special Tools .
2	Transfer Case Rear Output Shaft Flange Special Tools DT-48145 Press Support For equivalent regional tools, refer to Special Tools .
3	Transfer Case Rear Output Shaft Bearing Assembly NOTE: Use a press to remove the output shaft from the housing.
4	Transfer Case Rear Output Shaft Bearing Spacer
5	Transfer Case Rear Output Shaft
6	Transfer Case Rear Output Shaft Oil Slinger NOTE: Remove the slinger only if damaged. Refer to Rear Output Drive Housing Cleaning and Inspection .
7	Transfer Case Rear Output Shaft Seal NOTE: Discard the seal after removal.