Intermediate Drive Shaft Disassembly

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Intermediate Drive Shaft

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Half Shaft Retainer
2	O-ring
3	Front Wheel Drive Intermediate Shaft Bearing Retainer (Qty: 2)
4	Front Wheel Drive Intermediate Shaft Bearing Assembly Procedure Use a press, with the J 22912-B Rear Pinion and Axle Bearing Remover flat side up, in order to remove the bearing assembly. Special Tools J 22912-B Rear Pinion and Axle Bearing Remover For equivalent regional tools, refer to Special Tools .