Rear Output Shaft Housing Assembly

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Output Shaft Housing Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transfer Case Rear Output Shaft
2	Transfer Case Rear Output Shaft Bearing Spacer
3	Transfer Case Rear Output Shaft Housing
4	Transfer Case Rear Output Shaft Bearing Assembly Procedure Use a press with the J-5590 Pinion Bearing Race Installer - Rear to install the housing and bearings to the output shaft. Special Tools J-5590 Pinion Bearing Race Installer - Rear For equivalent regional tools, refer to Special Tools .
5	Transfer Case Rear Output Shaft Seal Procedure Use a press with the DT-48075 Output Shaft Seal Installer to install the seal. Special Tools DT-48075 Output Shaft Seal Installer For equivalent regional tools, refer to Special Tools .