LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 466 (Transfer Case - GETRAG 790) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Intermediate Drive Shaft Assembly

Intermediate Drive Shaft Assembly

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Intermediate Drive Shaft Components
GM1708858Courtesy of GENERAL MOTORS COMPANY
Intermediate Drive Shaft Assembly

Callout Component Name
1 Front Wheel Drive Intermediate Shaft
2 Front Wheel Drive Intermediate Shaft Bearing Retainer (Qty: 2)
3 Front Wheel Drive Intermediate Shaft Bearing Assembly
Procedure 
Use a press, with the DT-22912-B/KM-307-B  Rear Pinion and Axle Bearing Remover flat side up, in order to install the bearing assembly.
Special Tools 
DT-22912-B/KM-307-B  Rear Pinion and Axle Bearing Remover
For equivalent regional tools, refer to Special Tools .
4 O-ring
5 Half Shaft Retainer
scientia non olet · About LEMON Manuals