LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Exhaust System) >> Repair Instructions >> Exhaust Manifold Heat Shield Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Exhaust Manifold Heat Shield Bolts - Right Side
    GM1861575Courtesy of GENERAL MOTORS COMPANY
  1. Install the exhaust manifold heat shield.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the exhaust manifold heat shield bolts (1) and tighten to 10 N.m (89 lb in).
  3. Install the exhaust flexible pipe. Refer to Exhaust Flexible Pipe Replacement .
  4. Install the HO2S. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 .
scientia non olet · About LEMON Manuals