LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 460 (Automatic Transmission - 6T75 (M7V M7X) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transmission Mount & Bracket
    GM2003344Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission mount (2) and bracket (1) to the vehicle.
    2. Fig 2: View Of Transmission Mount Bracket Bolts
    GM2003343Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission mount bracket bolt (3) and tighten to 90 N.m (66 lb ft).
  3. Install the transmission mount bracket bolt (1) and tighten to 90 N.m (66 lb ft).
  4. Using the transmission jack, lower the transmission until the transmission mount bracket rests on the transmission mount.
  5. Install the transmission mount bracket bolt (2) and tighten to 90 N.m (66 lb ft).
  6. Remove the transmission jack.
    7. Fig 3: Identifying Transmission Mount Nuts
    GM2003342Courtesy of GENERAL MOTORS COMPANY
  7. Apply thread locker to the NEW nut, then install the transmission mount nut (2) and tighten to 75 N.m (55 lb ft).
  8. Apply thread locker to the NEW nut, then install the transmission mount nut (1) and tighten to 90 N.m (66 lb ft).
  9. Lower the vehicle
scientia non olet · About LEMON Manuals