LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 460 (Automatic Transmission - 6T75 (M7V M7X) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Replacement (Without Base) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake.
  2. Remove the front floor console. Front Floor Console Cover Replacement .
    3. Fig 1: Transmission Range Selector Lever Cable Terminal
    GM4197275Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the transmission range selector lever cable terminal (2) from the shift lever pin.
  4. Release the transmission range selector lever cable retainer (1) and remove the transmission range selector cable.
  5. Disconnect the transmission control electrical connector.
    6. Fig 2: Nut And Washer
    GM4489334Courtesy of GENERAL MOTORS COMPANY
  6. Remove the nut and washer (1) from the control assembly.
    7. Fig 3: Main Shaft Bolt
    GM4489340Courtesy of GENERAL MOTORS COMPANY
  7. Remove the main shaft bolt (1).
    8. Fig 4: Transmission Control Assembly
    GM4489344Courtesy of GENERAL MOTORS COMPANY
  8. Pull the transmission control assembly (1) rearward and upward to unseat it from the transmission control base.
  9. Remove the transmission control assembly from the vehicle.
scientia non olet · About LEMON Manuals