Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control valve body cover wiring connector hole seal.
- Install the control valve body cover gasket to the control valve body cover.
- Install the control valve body cover.
- Lower the transmission and remove the transmission jack.
- Install the 12 control valve body cover bolts (1) M6 x 30.
Tighten
Tighten the bolts in sequence to 12 N.m (106 lb in).
- Install the 2 control valve body cover studs (2) M6 x 30.
Tighten
Tighten the studs in sequence to 12 N.m (106 lb in).
- Connect the control valve body TCM electrical connector (1).
- Install the wire harness retainer (2) to the control valve body cover stud.
Tighten
Tighten the nut to 12 N.m (106 lb in).
- Lower the vehicle.
- Install the oil cooler outlet hose (4) to the retainer on the control valve body cover.
- Install the oil cooler outlet hose retainer nut (5) to the control valve body cover.
Tighten
Tighten the nut to 12 N.m (106 lb in).
- Install the oil cooler inlet hose (1) to the retainer on the control valve body cover.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Fill the transmission. Refer to Transmission Fluid Drain and Fill .
- Check for leaks.
NOTE:
The holes in the control valve body cover wiring connector hole seal must face toward the control solenoid valve assembly. If the holes face toward the valve body cover, there is a potential for a leak around the seal.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.