LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Driver >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, command the instrument panel cluster lamp test ON and OFF with a scan tool. The driver seat belt indicator should turn ON and OFF when changing between the commanded states.
    • If the indicator does not illuminate, replace the IPC.
  2. Observe the scan tool Driver Seat Belt Switch parameter while connecting and disconnecting the seat belt. The parameter should display Buckled and Unbuckled when changing between seat belt states.
scientia non olet · About LEMON Manuals