LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> Starter Solenoid Does Not Click >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool PNP Switch parameter while shifting the transmission. The reading should change between Park/Neutral and In Gear.
    • If not the specified values, refer to Park Switch Malfunction.
  2. Transmission in park, attempt to start the vehicle. The starter relay should click and the engine should begin cranking.
    • If the crank relay does not click or the engine does not crank, refer to CRNK Relay Malfunction.
  3. Ignition ON, observe the scan tool ECM Crankshaft Position Sensor Active Counter is not incrementing.
    • If the Crankshaft Position Sensor Active Counter is incrementing, replace the Crankshaft Position Sensor.
scientia non olet · About LEMON Manuals