LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1001: Option Configuration Error (Passenger Presence System) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.

  • PPS module
  • PPS module wiring harness
  1. Verify the correct PPS module part number has been installed
    • If the wrong PPS module part number was installed, replace with the correct PPS module.
  2. Verify that DTC B1001 is not set as current in the PPS module.
    • If DTC is set as current, perform the PPS Preload procedure. Verify the SDM is sending the correct key. If DTC resets replace the PPS module.
scientia non olet · About LEMON Manuals