Rear Side Door Window Upper Reveal Molding Replacement (Acadia/Traverse)

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Window Reveal Molding

Courtesy of GENERAL MOTORS COMPANY

Callous	Component Name
Preliminary Procedure Remove the rear side door window outer sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (Acadia/Traverse) .
1	Rear Side Door Window Upper Reveal Molding Lower Push Pin CAUTION: Refer to Fastener Caution . Procedure The push pin is located in the front lower door frame. Tighten 5 N.m (44 lb in)
2	Rear Side Door Window Upper Reveal Molding Upper Screw Procedure The screw is located in the upper rear corner of the door frame. NOTE: Replace the clip if damaged, transfer the clip to the new part.
3	Rear Side Door Window Upper Reveal Molding Rivets (Qty: 7) WARNING: Refer to Glass and Sheet Metal Handling Warning. Procedure Lower the window to the fully down position. When drilling cover/protect the interior trim and door from the metal shavings. The rivets are located in the inner upper door frame. Use a suitable tool, drill out the rivets from around the upper door frame.
4	Rear Side Door Window Upper Reveal Molding Procedure Use a suitable tool, install the rivets in the upper door frame.