Sunroof Window Height and Opening Fit Adjustment
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Cycle the sunroof window from full open to closed position.
- Loosen the adjusting screws on the window.
- Adjust the corners of the front window panel using the following guidelines:
- Adjust the front of the sunroof window to 1.0 mm - 1.5 mm (.04 in -.06 in) below the top surface of the roof panel.
- Adjust the rear center line of the sunroof window to 1.0 mm to 1.5 mm (.04 in to.06 in) proud of the top surface of the roof panel.
- Tighten the sunroof window adjustment screws to 5 N.m (44 lb in).
- Cycle sunroof window through all positions.
- Inspect the sunroof window adjustment. Adjust if necessary.
NOTE:
Correct adjustment cannot be achieved if the sunroof window is closed from vent position.
NOTE:
Do Not remove or lower headliner to access sunroof window screws.
CAUTION:
Refer to Fastener Caution .