LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Sunroof System) >> Repair Instructions >> Sunroof Sunshade Replacement (Front Manual) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the sunshade to the vehicle from the passengers side.
    2. Fig 1: Sunshade End And Bracket Notch
    GM1825483Courtesy of GENERAL MOTORS COMPANY
  2. Insert the end of the sunshade (1) to the driver side bracket (2) notch.
    3. Fig 2: Removing/Installing Sunshade From Bracket Notch
    GM1825482Courtesy of GENERAL MOTORS COMPANY
  3. Insert the sunshade (1) to the passengers side bracket (2) notch.
    4. Fig 3: Sunshade Cam Counterclockwise
    GM1825478Courtesy of GENERAL MOTORS COMPANY
  4. Turn the sunshade cam (2) until it is aligned with the bracket (3) notch.
  5. Install the sunshade.
    6. Fig 4: Sunshade Cam Locking Hole
    GM1825476Courtesy of GENERAL MOTORS COMPANY
  6. Remove the suitable tool (1) from the sunshade cam locking hole (2).
  7. Install the sunshade plastic pull cup back into the channel of the sunroof by engage the guide shoe of the channel on one side then push or pull back and forward to engage the opposite shoe into the track channel.
  8. Ensure that the sunshade cam (2) is fully seated in the bracket (3) and the sunshade slides smoothly.
  9. Power the sunroof module window tracks to the fully closed position.
  10. Install the sunroof window. Refer to Sunroof Window Replacement .
  11. Verify the operation of the sunshade.
scientia non olet · About LEMON Manuals