Component Testing
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- With the ignition OFF, disconnect the harness connector at the sunroof switch.
- Test for infinite resistance between the switch terminals listed below and the ground terminal B with the switch in the open position.
- Roof open terminal D
- Roof close terminal E
- If not the specified value, replace the sunroof switch.
- Test for less than 50 Ω of resistance between the switch terminals listed below and the ground terminal B with the switch in the appropriate position.
- Roof open terminal D
- Roof close terminal E
- If greater than the specified range, replace the sunroof switch.
NOTE:
If the switch tests open in any switch position other than Off, test the sunroof switch signal circuits for a short to voltage before replacing the switch.