LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Steering Wheel And Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intermediate Steering Shaft Boot
    GM1856325Courtesy of GENERAL MOTORS COMPANY
  1. Install the intermediate steering shaft boot (1).
    2. Fig 2: Intermediate Steering Shaft Bolt
    GM1853880Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    A NEW intermediate steering shaft lower bolt has a thread locking adhesive patch on the threads.

  2. Connect the intermediate steering shaft to the steering gear. Install the NEW intermediate steering shaft lower bolt (1) and tighten to 25 N.m (18 lb ft).
    3. NOTE:

    Install the intermediate steering shaft boot in the correct position.

  3. Install the intermediate steering shaft boot to the steering gear and to the intermediate steering shaft upper seal.
  4. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals