LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Steering Wheel And Steering Column) >> Diagnostic Information and Procedures >> DTC B2890: Tilt and Telescope Motor Circuit Calibration Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, perform the scan tool Learn Column Soft Stops procedure. Refer to Telescoping Steering Column Calibration .
  2. Operate the vehicle within the Conditions for Running and Setting. Verify DTC B2890 does not reset.
    • If the DTC resets, replace the seat memory control module.
scientia non olet · About LEMON Manuals