LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Steering Wheel And Steering Column) >> Diagnostic Information and Procedures >> DTC B2860 or B2880: Telescope Position Sensor >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

B2860 01 

The steering column telescope sensor signal voltage is greater than 4.8 volts for more than 2 seconds.

B2860 06 

The steering column telescope sensor signal voltage is less than 0.2 volt for more than 2 seconds.

B2860 5A 

An incorrect steering column telescope sensor signal voltage is seen.

B2860 61 

The steering column telescope sensor signal voltage does not change when the telescope actuator is commanded.

B2880 01 

The steering column tilt sensor signal voltage is greater than 4.8 volts for more than 2 seconds.

B2880 06 

The steering column tilt sensor signal voltage is less than 0.2 volt for more than 2 seconds.

B2880 5A 

An incorrect steering column tilt sensor signal voltage is seen.

B2880 61 

The steering column tilt sensor signal voltage does not change when the telescope actuator is commanded.