LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Steering Wheel And Steering Column) >> Diagnostic Information and Procedures >> DTC B2860 or B2880: Telescope Position Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Tilt Sensor and Telescope Sensor parameter. The readings should be between 0.2 and 4.8 volts.
    • If not within the specified range, refer to Tilt/Telescope Sensor Circuit Malfunction.
  2. Command the column to tilt up and down and telescope in and out using the tilt/telescope switch. The column should move in the commanded direction.
    • If the column does not operate as specified, refer to Tilt/Telescope Actuator Circuit Malfunction.
scientia non olet · About LEMON Manuals