LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body & Bolts
    GM1858235Courtesy of GENERAL MOTORS COMPANY
  1. Position a NEW throttle body gasket (1) and throttle body (2) to the upper intake manifold.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the throttle body bolts (3).

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Electronic Throttle Control
    GM1858234Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector (2) to the electronic throttle control (1).
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Perform the throttle learn procedure. Refer to Q38 Throttle Body: Throttle/Idle Learn .
scientia non olet · About LEMON Manuals