LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
  3. Remove Catalytic Converter - Left Side Catalytic Converter Replacement - Left Side
  4. Lower the vehicle.
  5. Disconnect the engine wiring harness electrical connector (2) from the bank 2 knock sensor (3).
    6. Fig 2: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS COMPANY
  6. Loosen the knock sensor bolt and remove the knock sensor.
scientia non olet · About LEMON Manuals