LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten 

    Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (2) to the bank 2 knock sensor (3).
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Install Catalytic Converter - Left Side Catalytic Converter Replacement - Left Side
  5. Install a NEW engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals