LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement - Bank 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1858010Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold. Refer to Intake Manifold Replacement
  2. Disconnect the engine wiring harness electrical connector(s) (5) from the ignition coil(s) (4).
    3. Fig 2: Identifying Left Cylinder Head Ignition Coils
    GM868186Courtesy of GENERAL MOTORS COMPANY
  3. Remove the ignition coil bolt(s).
  4. Remove the ignition coil(s).
scientia non olet · About LEMON Manuals