Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ignition coil(s).
- Install the ignition coil bolt(s).
Tighten
Tighten the bolt(s) to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector(s) (5) to the ignition coil(s) (4).
- Install the intake manifold. Refer to Intake Manifold Replacement
CAUTION:
Refer to Fastener Caution .