LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Fuel Pump Replacement (LLT) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the low and high side fuel system pressure. Refer to Fuel Pressure Relief Fuel Pressure Relief (High Side) .
  2. Remove the thermostat housing. Refer to Engine Coolant Thermostat Housing Replacement .
    3. Fig 1: Identifying High Pressure Fuel Pump Components
    GM2221135Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the engine wiring harness electrical connector from the high pressure fuel pump.
  4. Remove the low pressure feed pipe. Discard the pipe. Refer to Fuel Feed Pipe Replacement (LLT) .
  5. Remove the high pressure pipe. Discard the pipe. Refer to Fuel Feed Intermediate Pipe Replacement (LLT) . Discard this pipe.
    6. CAUTION:

    Alternately loosen the fuel pump bolts one turn at a time until the pump is fully disengaged from fuel pump lifter follower. Trying to remove the pump bolts without even side-to-side loosening may result in pump plunger damage

  6. Remove and discard the high pressure fuel pump bolts (1).
  7. Remove the high pressure fuel pump (2).
  8. Remove and DISCARD the high pressure fuel pump O-ring (3).
  9. Remove and DISCARD the high pressure fuel pump gasket (4).
  10. Remove the high pressure fuel pump roller lifter (5).
scientia non olet · About LEMON Manuals