LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Module Bucket
    GM1860246Courtesy of GENERAL MOTORS COMPANY
  1. Position the fuel level sensor to the module bucket and slide the sensor down.
    2. Fig 2: View Of Module Wiring Clip
    GM1860673Courtesy of GENERAL MOTORS COMPANY
  2. Ensure that the fuel level sensor tabs (1) engage the module bucket.
  3. Install the fuel level sensor wiring under the module clip (2).
    4. Fig 3: View Of Fuel Level Sensor Electrical Connector
    GM1860672Courtesy of GENERAL MOTORS COMPANY
  4. Connect the fuel level sensor electrical connector (1) to the module cover.
  5. Install the fuel tank module. Refer to Fuel Tank Module Replacement .
scientia non olet · About LEMON Manuals