LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1858010Courtesy of GENERAL MOTORS COMPANY
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill)Cooling System Draining and Filling (Vac N Fill) .
  2. Slide the electrical connector heat shield up the wiring harness.
  3. Disconnect the engine wiring harness electrical connector (8) from the engine coolant temperature (ECT) sensor (9).
    4. Fig 2: View Of ECT Sensor
    GM1836047Courtesy of GENERAL MOTORS COMPANY
  4. Remove the ECT sensor.
scientia non olet · About LEMON Manuals