LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2010 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Knock Sensor & crankshaft position (CKP) sensor Electrical Connectors
    GM1860405Courtesy of GENERAL MOTORS COMPANY
  1. Remove the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement .
  2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (4).
    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS COMPANY
  3. Remove the crankshaft sensor bolt.
  4. Remove the crankshaft sensor.
scientia non olet · About LEMON Manuals